Selecting a Remote Scan Mode

There are three Remote Scan modes: Simple Scan, Manual Scan, and Secure Scan.

In Simple Scan mode, you can start scanning anytime if the machine is in standby status.

In Manual Scan mode, you must turn Remote Scan on the operator panel before starting scanning.

In Secure Scan mode, you can operate only from a specified computer. Only one computer can be connected at a time.

If you perform a remote scan via the WSD Scan connection, you can start scanning only from computers that are already registered in this machine, regardless of the Remote Scan modes.

Using WSD Scan

  1. Press (SETTING).

  2. Press to select [Admin Setup], and then press (OK).

  3. Enter the administrator password.

  4. Select [Enter], and then press (OK).

  5. Press to select [Scanner Setup], and then press (OK).

  6. Press to select [PC Scan Mode], and then press (OK).

    Available scan modes

    Simple Scan mode*,Manual Scan mode,Secure Scan mode

    * indicates the factory default setting.

  7. Press to select a mode, and then press (OK).

  8. Press until the top screen is displayed.